Emerson R&S SGT100A User Manual page 517

®
R&S SGT100A
[:SOURce<hw>]:PULM:TRIGger:EXTernal:GATE:POLarity
[:SOURce<hw>]:PULM:TRIGger:EXTernal:IMPedance
[:SOURce<hw>]:PULM:TRIGger:EXTernal:SLOPe
[:SOURce<hw>]:PULM:TRIGger:MODE
[:SOURce<hw>]:PULM:WIDTh
[:SOURce<hw>]:PULM:DELay <Delay>
Sets the pulse delay.
Parameters:
<Delay>
Example:
[:SOURce<hw>]:PULM:DOUBle:DELay <Delay>
Sets the delay from the start of the first pulse to the start of the second pulse.
Parameters:
<Delay>
Example:
Manual operation:
[:SOURce<hw>]:PULM:DOUBle:WIDTh <Width>
Sets the width of the second pulse in case of double pulse generation.
Example:
Manual operation:
[:SOURce<hw>]:PULM:MODE <Mode>
Sets the mode of the pulse generator.
Parameters:
<Mode>
User Manual 1176.8674.02 ─ 12
........................................................................... 520
........................................................................................ 520
float
Range: 0 to 100 s
Increment: 10 ns
*RST: 10 ns
PULM:DEL 13 us
13 us elapse after a trigger before the first pulse is generated.
float
Range: 40 ns to 100 s
Increment: 10 ns
*RST: 1 ns
PULM:DOUB:DEL 22 us
22 us elapse between the beginning of the first pulse and the
beginning of the second pulse in double-pulse mode.
See "Double Pulse Delay"
PULM:DOUB:WIDT 33 us
sets a width of 33 us for the second pulse.
See "Double Pulse Width"
SINGle | DOUBle
SINGle
Enables single pulse generation.
Remote control commands
SOURce subsystem
.................................................519
...................................................... 519
............................................................ 519
on page 258
on page 258
517