Settings: State; Set To Default - Emerson R&S SGT100A User Manual

®
R&S SGT100A
The remote commands required to define these settings are described in
ter 10.14.13, "SOURce:IQ:OUTPut:ENVelope
Settings:
State............................................................................................................................177
Set to
Save/Recall................................................................................................................. 178
RF Envelope............................................................................................................... 178
Envelope Voltage
eTrak
I/Q Output
Envelope Voltage
V Min/Max.................................................................................................................179
out
Bias............................................................................................................................. 179
DC Modulator
PA characteristics........................................................................................................182
State
Enables/disables the analog I/Q output.
Note: By default, these output connectors are deactivated.
Remote command:
[:SOURce<hw>]:IQ:OUTPut:ANALog:STATe

Set to Default

Calls the default settings. The values of the main parameters are listed in the following
table.
Parameter
"State"
"RF Envelope"
"I/Q Output Type"
"I/Q Level Vp (EMF)"
"Bias (EMF)"
User Manual 1176.8674.02 ─ 12
Default.............................................................................................................. 177
Adaptation...................................................................................... 178
®
Interface Type..................................................................................................178
Type...........................................................................................................179
Reference.......................................................................................179
characteristics...................................................................................... 180
└ EMF.............................................................................................................. 180
└ R ................................................................................................................. 180
in
└ Termination................................................................................................... 180
└ Bipolar Input..................................................................................................181
└ V Max.......................................................................................................... 182
pp
└ Gain.............................................................................................................. 182
└ V Offset........................................................................................................182
cc
└ V Min/Max....................................................................................................183
cc
└ Power Offset................................................................................................. 183
└ PEP Min/Max............................................................................................... 184
in
Value
Not affected by the "Set to Default"
Off
Single Ended
1 V
0 mV
Signal generator settings
Generation of envelope tracking signals
commands", on page 485.
on page 481
Chap-
177