Channel Spacing; Signal Bandwidth; Stopband Frequency; Passband Frequency - Emerson R&S SGT100A User Manual

®
R&S SGT100A
"Enhanced"
Remote command:
[:SOURce<hw>]:BB:ARBitrary:CFR:FILTer

Channel Spacing

Requires "Algorithm" > "Clipping and Filtering" and "Filter Mode" > "Simple".
Sets the channel spacing.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:CFR:CSPacing

Signal Bandwidth

Requires "Algorithm" > "Clipping and Filtering" and "Filter Mode" > "Simple".
Sets the signal bandwidth. Set a value that is lower than the value of the "Channel
Spacing".
Remote command:
[:SOURce<hw>]:BB:ARBitrary:CFR:SBANdwidth

Stopband Frequency

Requires "Algorithm" > "Clipping and Filtering" and "Filter Mode" > "Enhanced".
Sets the stopband frequency of the filter. Frequency components higher than the stop-
band frequency are filtered out by the lowpass filter.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:CFR:SFReq

Passband Frequency

Requires "Algorithm" > "Clipping and Filtering" and "Filter Mode" > "Enhanced".
Sets the passband frequency. Frequency components lower than the passband fre-
quency are passed through unfiltered.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:CFR:PFReq
User Manual 1176.8674.02 ─ 12
In the enhanced filter mode, you can specify the passband and stop-
band frequencies of the lowpass filter.
Figure 6-3: Enhanced filter mode
Signal generator settings
on page 451
on page 451
on page 453
on page 454
on page 453
Baseband
140