Emerson R&S SGT100A User Manual page 531

®
R&S SGT100A
:STATus:OPERation:PTRansition <Ptransition>
Sets the bits of the PTRansition part of the STATus:OPERation register. If a bit is set, a
transition from 0 to 1 in the condition part causes an entry to be made in the EVENt
part of the register. A new event in the hardware is thus registered, for example the
start of an adjustment.
Parameters:
<Ptransition>
Example:
:STATus:PRESet <Preset>
Resets the status registers. All PTRansition parts are set to FFFFh (32767), i.e. all
transitions from 0 to 1 are detected. All NTRansition parts are set to 0, i.e. a transition
from 1 to 0 in a CONDition bit is not detected. The ENABle parts of STATus:OPERation
and STATus:QUEStionable are set to 0, i.e. all events in these registers are not passed
on.
Parameters:
<Preset>
Example:
:STATus:QUEStionable:CONDition <Condition>
Queries the content of the CONDition part of the STATus:QUEStionable register. This
part contains information on the action currently being performed in the instrument.
The content is not deleted after being read out since it indicates the current hardware
status.
Parameters:
<Condition>
Example:
:STATus:QUEStionable:ENABle <Enable>
Sets the bits of the ENABle part of the STATus:QUEStionable register. The enable part
determines which events of the STATus:EVENt part are enabled for the summary bit in
the status byte. These events can be used for a service request.
If a bit in the ENABle part is 1, and the correesponding EVENt bit is true, a positive
transition occurs in the summary bit. This transition is reportet to the next higher level.
Parameters:
<Enable>
User Manual 1176.8674.02 ─ 12
string
:STAT:OPER:PTR 32767
all transitions from 0 to 1 in the condition part of the Status:Oper-
ation register cause an entry to be made in the EVENt part.
string
STAT:PRES
resets the status registers.
string
:STATus:QUEStionable:CONDition?
queries the Status:Questionable:Condition register.
string
Remote control commands
STATus subsystem
531