Emerson R&S SGT100A User Manual page 61

®
R&S SGT100A
See also
Hardware Channel
Selects the hardware interface used by the remote channel.
Remote command:
:INSTruments:REMote:CHANnel
Instrument Name / IP Address
Enters the IP address or the host name of the connected instrument.
See also
on page 74.
Remote command:
:INSTruments:REMote:NAME
GPIB Address
Enters the GPIB address of the connected instrument.
See also
Remote command:
:INSTruments:GPIB:ADDRess
Board Number
Identifies the GPIB bus card of the controller to that the adapter is connected.
See also
Remote command:
:INSTruments:GPIB:BOARd
Serial Number
Enters the serial number as instrument's identification while using the USB or PCIe
interfaces for remote control.
Remote command:
:INSTruments:SERial
Ok
Confirms the settings and closes the dialog.
Apply
Confirms the settings.
Cancel
Discards settings and closes the dialog.
User Manual 1176.8674.02 ─ 12
Chapter 5.5.4, "Bidirectional instrument
Chapter 5.5.3, "Finding out the default hostname of the
Chapter 9.1.5, "GPIB interface (IEC/IEEE bus
Chapter 9.1.5, "GPIB interface (IEC/IEEE bus
on page 83
Understanding R&S SGMA-GUI
identification",
on page 81
on page 82
on page 80
on page 81
Operating menu and toolbar
on page 74.
instrument",
interface)", on page 320.
interface)", on page 320.
61