Network Setup; Using The Field Communicator; Using Ams Wireless Configurator Or Ams Device Manager - Emerson TopWorx 4310 Instruction Manual

Instruction Manual
D103391X012

Network Setup

The 4310 should have wireless network parameters configured prior to becoming part of a wireless network. All
WirelessHART devices within a network have two network parameters that are the same; the Network ID and the Join
Key.
The 4310 is shipped with a pre‐configured Network ID of 1229 and a Join Key which is set to all zeros. Prior to being
installed these should be set to match the other devices on the network. These configuration changes can be made
using a 475 or 375 Field Communicator, AMS Wireless Configurator, or AMS Device Manager 10.5 and above.
Note
When the 1420 gateway is configured in an advanced security mode each device is required to have an individual join key.

Using the Field Communicator

1. Verify the Field Communicator has the 4310 (Device Revision 2) device description (DD) loaded.
Note
4310 DD's for the Field Communicator are available for download at:
http://www2.emersonprocess.com/en-US/brands/Field-Communicator/Pages/SysSoftDDs.aspx
Click on "See a list of any new released Device Description..." under Latest Device Descriptions to access
ftp://ftp.emersonprocess.com/AO/downloads/RecentDDs/RecentDDs.pdf. This PDF file contains live links to the newly released
DD's.
Note that there may be a delay in posting new DD's to this site.
2. Obtain the Network ID and Join Key from the 1420 gateway via web interface. Go to Setup, then select Network. The
Network ID will be shown. Select "Yes" to see the Join Key.
3. Open the cover of the 4310 and attach the Field Communicator leads to the 4310 HART terminals (see figure 2 or
figure 5).
4. Select Online, Overview, Join Device to Network to enter the network parameter settings (see figure 20 for the
Overview menu tree).
5. Remove the leads from the 4310 and close the cover.
6. Install the 4310 on monitored equipment and/or verify the 1420 gateway.
Using AMS Wireless Configurator or AMS Device Manager (Using a HART Modem)
1. Verify that AMS has the 4310 (Device Revision 2) device description (DD) loaded.
Note
4310 DD's for AMS are available for download at:
http://www2.emersonprocess.com/en-US/documentation/deviceinstallkits/Pages/deviceinstallkitsearch.aspx
Note that there may be a delay in posting new DD's to this site.
4310 Wireless Position Monitor
December 2011
9