Calibrating Header Position Sensors On Harvesttouch ™ Display - MacDon R113 Unloading And Assembly Instructions

Calibrating Header Position Sensors on HarvestTouch
The header position sensors need to be recalibrated whenever the HarvestTouch
replaced, sensor readouts are erratic, a pump has been replaced, or when a new header type or attachment is connected
to the windrower.
DANGER
Ensure that all bystanders have cleared the area.
NOTE:
This calibration MUST be performed with the engine running and the header engaged.
1. Start the engine.
2. Engage the header.
NOTE:
Once the header is engaged, header gauges (A) will appear
™
on the HarvestTouch
3. Select SETUP (A).
262300
ATTACHING HYDRAULIC AND ELECTRICAL COMPONENTS
Display home page.
™
Display
™
Display is replaced, a position sensor is
Figure 6.41: HarvestTouch
Figure 6.42: Main Menu
80
A
™
Display
A
B
Revision A