6. Press SELECT (D) until AUGER SPEED is displayed
on the upper line.
• ENABLED/LOCKED is displayed on the lower line.
7. Press left (B) arrow to enable AUGER SPEED
control switch.
Press right (C) arrow to lock AUGER SPEED
control switch.
8. Press PROGRAM (A) to exit Programming Mode, or
press SELECT (D) to proceed to next WINDROWER
SETUP action.
4.5.6 Activating the Reel Speed Control Lockout
NOTE:
The header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
147962
CAB DISPLAY MODULE (CDM)
Figure 4.191: M105 Auger Control Lock
Figure 4.192: M155 Auger Control Lock
Figure 4.193: M205 Auger Control Lock
237
Revision A