Table of Contents
Advertisement
rprbk203 Page 31 Tuesday, February 16, 1999 9:12 AM
4. Install the daughter board:
a) Line up the connector on the bottom of the
daughter board with the U25 socket on the control
PCP.
Refer to Figure 3-14.
Be very careful to keep the connectors straight
when fitting them into the socket.
b) Press straight down to seat the board in the socket.
See this
Installation note
There are two small bead tantalum
capacitors (C52 and C53) just
above the U25 socket.
Very gently press them sideways, to
allow the board to be properly
seated.
Refer to Figure 3-14.
5. Replace the control PCP in the PCP assembly frame
if you removed it.
6. Replace the PCP assembly into the terminal, if you re-
moved it.
7. Reconnect all the cables, including:
a) Connect the J39 end of the smart card alert inter-
connect cable (Figure 3-15) to J52 on the keypad
PCP (Figure 3-16) or to J52 on the external inter-
face module (Figure 3-17).
Note: This connection depends on what version of
the upper bezel assembly is in the terminal.
b) Route the cable so it reaches the control-board
side of the terminal.
c) Connect the J38 end of the interconnect cable,
shown in Figure 3-15, to the connector on the
smart card alert daughter board (J36).
Millennium Multi-pay-based terminals: replacing parts
PCP assembly components 3-31
Advertisement
Table of Contents
