Table of Contents
Advertisement
rprbk203 Page 32 Tuesday, February 16, 1999 9:12 AM
5-32 Card and hookswitch parts
NTP: 506-6501-203 Issue: 00.01 Status: Standard Date: June 1998
7. Module A: Route the cable from the hookswitch mod-
ule through the cable clamp below the module and re-
connect the module to the keypad connector.
Module B: Reconnect the mylar keypad PCP cable to
the hookswitch module (J53).
Reconnect the alerter cable or the smart card alert ca-
ble to J52.
8. Reinstall the PCP assembly as explained in Remov-
ing the PCP assembly on page 3-2.
9. Restore the terminal to operation.
Refer to Restoring the terminal to operation on
page 2-10, if necessary.
a) Reconnect the power to the terminal by recon-
necting the terminal block to the rear terminal PCP.
b) Remove your ESD strap connection.
c) Close and lock the terminal.
10. Test the terminal function to ensure the new compo-
nents work.
Advertisement
Table of Contents
