Nortel Millennium M1000 Manual page 59

rprbk203 Page 31 Tuesday, February 16, 1999 9:12 AM
Figure 2-19: Close-up of rear terminal PCP
2. Disconnect cables from the module:
a) Disconnect the rear terminal PCP cable (J18) from
the control PCP connector (J5).
b) Disconnect the security PCP cable (J31) from the
rear terminal PCP connector (J32).
c) If the terminal has an IAS module, disconnect the
interconnect cable between the IAS module and
the rear terminal PCP.
3. Remove the rear terminal PCP retaining screw.
Refer to Figure 2-19.
4. Remove the rear terminal PCP from the mount.
Rear terminal housing
Upper terminal block
Rear terminal
PCP
Retaining
screw
5. Reverse steps 2 to 3 to replace the PCP.
• When inserting the new PCP, make sure the align-
ment pins on the terminal mount fit into the holes in
the housing assembly.
Millennium Multi-pay-based terminals: replacing parts
Accessing the terminal 2-31
Rear terminal
rain diverter
slides behind
rear terminal
mount
(optional
feature)
Rear terminal
mount