Table of Contents
Advertisement
rprbk203 Page 18 Tuesday, February 16, 1999 9:12 AM
3-18 PCP assembly components
Figure 3-9: Lining up the chip in the socket
X1
NTP: 506-6501-203 Issue: 00.01 Status: Standard Date: June 1998
U2
angled corner
6. Replace the control PCP and the PCP assembly re-
versing the steps in Removing the telephony or
control PCPs on page 3-11 and Removing the PCP
assembly on page 3-2.
7. When you are ready to close the terminal, reconnect
the power by connecting the terminal block to the rear
terminal PCP and restore the terminal to operation.
Refer to Restoring the terminal to operation on
page 2-10, if necessary.
8. Perform the INSTALL routine in the craft interface.
9. Perform operation tests to ensure that the terminal
works properly.
The tests performed will depend on the version of the
firmware. Contact your Technical Assistance Manag-
er (TAM) for the correct testing procedure.
U16
U26
Advertisement
Table of Contents
