Nortel Millennium M1000 Manual page 147

rprbk203 Page 5 Tuesday, February 16, 1999 9:12 AM
Figure 5-4: Card reader screws
5. Remove the assembly from the housing:
a) Remove the M5 tapping screw located under the
card reader, in the middle. Use a #2 type 1A cross-
recess screwdriver. Refer to Figure 5-4.
b) Remove the two M3.5 tapping screws located on
either side of the M5 screw. Use a #1 type 1A
cross-recess screwdriver. Refer to Figure 5-4.
These three screws attach the card reader bezel to the
front housing assembly.
c) If you are removing a multi-card reader, loosen
three turns the bottom two screws on the keypad
PCP, which hold the quick access keys bezel.
This releases the interlock tab at the top of the card
reader bezel. Refer to Figure 5-4.
Top of front
housing
d) Lift the front housing and remove the card reader
assembly from the front of the terminal. An
example of the card reader assembly is shown in
Figure 5-5.
Millennium Multi-pay-based terminals: replacing parts
Card and hookswitch parts 5-5
Screws securing the
card reader bezel
to the front housing
Card reader
Screws securing
interlock tab
(loosen 3 turns)
Keypad PCP