Nortel Millennium M1000 Manual page 125

rprbk203 Page 19 Tuesday, February 16, 1999 9:12 AM
Figure 4-16: Quick access keys screws
Top of
front
housing
Figure 4-17: Removing the quick access keys bezel
2. Remove the two M3.5 tapping screws securing the
quick access keys bezel above the card reader on the
inside of the upper housing.
Use a #2 type 1A cross-recess screwdriver.
These screws are labelled in Figure 4-16.
3. Lift the upper housing until you can remove the quick
access keys bezel by pulling it from the front of the ter-
minal. Refer to Figure 4-17.
Note: Keep the bezel slightly tilted forward to prevent
the keys from falling out of it.
Note: Keys are loose.
Remove bezel with
care.
Millennium Multi-pay-based terminals: replacing parts
Upper bezel components 4-19
Card reader
Keypad PCP
Screws to
attach quick
access keys
Quick access keys
label window
Quick access
keys bezel