Nortel Millennium M1000 Manual page 204

rprbk203 Page 22 Tuesday, February 16, 1999 9:12 AM
6-22 Coin path modules
Figure 6-18: Locating ID bezel screws inside the front housing
Remove these ID bezel screws
NTP: 506-6501-203 Issue: 00.01 Status: Standard Date: June 1998
Electrostatic • Before working with the inter-
discharge
(ESD)
• Place any components you re-
Warning
• Disconnect the supplementary
• Do not reconnect the power
Failure to follow these precautions may damage
the ESD-sensitive components of the PCPs.
VFD
2. Remove the coin slot gasket, shown in Figure 6-18,
and set aside.
3. Use one hand to support the ID bezel from the outside
of the terminal.
nal boards, put on your ESD
wrist strap and connect it to an
ESD connection point inside
the terminal.
move from the terminal into an
anti-static bag.
power supply.
until you are ready to close
the terminal.
Coin slot gasket