Nortel Millennium M1000 Manual page 178

rprbk203 Page 36 Tuesday, February 16, 1999 9:12 AM
5-36 Card and hookswitch parts
Figure 5-33: Hookswitch bezel screws
Alerter
PCP
Screws securing
the
hookswitch/
alerter bezel
Hookswitch
PCP
NTP: 506-6501-203 Issue: 00.01 Status: Standard Date: June 1998
• removed the alerter module as explained in
Replacing the alerter module on page 5-19
• removed the hookswitch module as explained in
Replacing the hookswitch module on page 5-25
2. Remove the hookswitch/alerter bezel:
a) Support the bezel from the front of the terminal,
then remove the two M3.5 tapping screws
securing the hookswitch/alerter bezel.
• Use a #2 type 1A cross-recess screw-
driver.
• Refer to Figure 5-33 to locate the screws.
b) Remove the hookswitch/alerter bezel by pulling it
from the front of the terminal.
3. To replace the hookswitch/alerter bezel, reverse the
preceding steps.
4. Reassemble and reconnect the alerter module and
hookswitch module.
Keypad PCP
Top of
front
housing