rprbk203 Page 17 Tuesday, February 16, 1999 9:12 AM
Figure 6-14: Coin escrow hex nut inside the coin vault
t
2. Remove the escrow module.
•
Top-mounted escrows: Start at step 3.
•
Escrows secured through the coin vault:
— Remove the coin box as explained in Re-
placing the vault door or the coin box
on page 6-25
— Remove the hex nut accessed through
the coin vault on the underside of the
vault top through the coin box rail, as indi-
cated in Figure 6-14.
3. Push the securing tab, labelled in Figure 6-15, so it
clears the vault top in the return cutout.
4. Lift the escrow until the locating pin on the bottom
clears its rectangular hole in the vault top.
Millennium Multi-pay-based terminals: replacing parts
Coin path modules 6-17
Coin box
rail assembly
The hex nut goes
into this hole.
Coin
vault