Nortel Millennium M1000 Manual page 244

rprbk203 Page 6 Tuesday, February 16, 1999 9:12 AM
7-6 Coin basic w/o display
Figure 7-3: Positioning the portable display over the clamp plate
NTP: 506-6501-203 Issue: 00.01 Status: Standard Date: June 1998
4. Attach the display:
a) Lift the PCP assembly by the plastic frame.
Note: You may need to disconnect the keypad
cable (J1A) and the handset teladapt plug (J10B)
if these cables are not long enough to allow you to
lift the PCP assembly sufficiently to reach the
display connector.
See this If there is an internal instruction
card with no cutout for the VFD, you
need to remove the PCP assembly
to access the clamp plate.
Refer to Installing an internal
instruction card on page 4-34 for
a detailed procedure.
b) Remove the black plastic window cover from the
clamp plate and set aside.
c) Seat the temporary display over the four screw
posts on the clamp plate.
The edge of the display with the cable connector
should be closest to the top of the terminal.
Portable
display
in position
on the
clamp plate
Connect to
control PCP
Clamp
plate
Top of front
housing