Table of Contents
Advertisement
rprbk203 Page 44 Tuesday, February 16, 1999 9:12 AM
6-44 Coin path modules
Figure 6-35: Vault-side (inside) view of e-lock
Back of vault
NTP: 506-6501-203 Issue: 00.01 Status: Standard Date: June 1998
2. Close the terminal housing, but do not lock it.
3. Open the coin vault as explained in Replacing the
vault door or the coin box on page 6-25.
4. Remove the security module as described in Replac-
ing the security PCP on page 6-34.
5. Remove the mechanical lock as described in Replac-
ing the coin vault lock on page 6-38.
6. Position the e-lock on the inside of the vault.
The four holes will line up with the screw holes on the
terminal shell, allowing the keyhole to fit through the
appropriate hold in the housing.
Refer to Figure 6-35 for screw hole locations.
7. Replace the two screws above the lock.
8. Feed the connector and cable of the security switch
up through the hole between the vault and the termi-
nal chassis.
The hole is located in the back, right-hand corner of
the vault between the coin box rail and the interior wall
of the vault.
9. Position the security switch and mount underneath
the e-lock.
Vault opening
Screw holes
to secure lock
to housing
Advertisement
Table of Contents
