Table of Contents
Advertisement
rprbk203 Page 19 Tuesday, February 16, 1999 9:12 AM
Figure 6-16: Positioning the escrow rain shield
Escrow
Rain
shield
7. If you are installing a new escrow, attach the rain
shield to the escrow once it is seated back in the ter-
minal. The positioning of the rain shield is shown in
Figure 6-16.
a) Remove the top screw and the bottom left screw
from the escrow PCP board.
b) Position the shield over the PCP and replace the
screws.
8. Restore the coin path:
a) Replace the coin box.
Refer to Replacing the vault door or the coin
box on page 6-25.
b) Replace the validator.
Refer to Replacing the coin validator on page 6-
6.
c) Reconnect the cables, including the validator-to-
escrow connection.
Millennium Multi-pay-based terminals: replacing parts
Coin path modules 6-19
Fit notch
around
projection
on side of
escrow
Remove
these
screws
to install
rain shield
Advertisement
Table of Contents
