Nortel Millennium M1000 Manual page 92

rprbk203 Page 24 Tuesday, February 16, 1999 9:12 AM
3-24 PCP assembly components
Figure 3-12: Installing SAM daughter board
Note missing pin
SAM daughter board
NTP: 506-6501-203 Issue: 00.01 Status: Standard Date: June 1998
Daughter board
connects to male
connectors on
control PCP
5. Press the board straight down until the connectors are
properly seated.
6. Replace the control PCP into the PCP assembly.
Refer to Removing the telephony or control PCPs
on page 3-11, if necessary .
7. Replace the PCP assembly into the terminal.
Refer to Removing the PCP assembly on page 3-2,
if necessary.
8. Reconnect all cables to the PCP assembly.
9. Restore the terminal to operation.
Refer to Restoring the terminal to operation on
page 2-10, if necessary.
a) Reconnect the power to the terminal by recon-
necting the terminal block to the rear terminal PCP.
b) Remove your ESD strap connection.
c) Close and lock the terminal.