rprbk203 Page 24 Tuesday, February 16, 1999 9:12 AM
5-24 Card and hookswitch parts
Figure 5-21: Locating the alerter module
Alerter PCP
Remove these
M3.5 screws
Access hole
to number
card
NTP: 506-6501-203 Issue: 00.01 Status: Standard Date: June 1998
4. To replace the alerter module, reverse the preceding
steps. Ensure you connect the cable to the correct
connection point.
5. If you removed it, reinstall the PCP assembly.
Refer to Removing the PCP assembly on page 3-2,
if necessary.
6. Restore the terminal to operation.
Refer to Restoring the terminal to operation on
page 2-10, if necessary.
a) Reconnect the power to the terminal by recon-
necting the terminal block to the rear terminal PCP.
b) Remove your ESD strap connection.
c) Close and lock the terminal.
7. Perform function tests.
Card reader
Top of
front
housing