Nortel Millennium M1000 Manual page 236

rprbk203 Page 54 Tuesday, February 16, 1999 9:12 AM
6-54 Coin path modules
Figure 6-44: Coin return bracket in place
Rear housing
Left hinge
Insert 20 mm
long screw to hold
bracket
Coin return
bracket
(installed)
Coin return
exit chute
NTP: 506-6501-203 Issue: 00.01 Status: Standard Date: June 1998
4. Optional step: Check proper positioning of the brack-
et:
a) Unscrew the coin return retainer screw.
Refer to Figure 6-44.
b) Insert two fingers into the coin return chute and
hook them around the flap.
c) Attempt to lift the coin return assembly up and at
the same time swing the bottom away from the
terminal. If the bracket is positioned properly, the
assembly may move slightly, but you will not be
able to pull it forward.
5. Once the bracket is properly positioned, insert and
tighten the long 20 mm screw into the hinge bracket.
6. Re-insert the coin return retainer screw and screw in
until it sits tightly against the top of the coin return.
Coin return
retainer screw