Nortel Millennium M1000 Manual page 218

rprbk203 Page 36 Tuesday, February 16, 1999 9:12 AM
6-36 Coin path modules
Figure 6-30: Rear terminal PCP security connector
Rear terminal PCP
Cable
clamp
NTP: 506-6501-203 Issue: 00.01 Status: Standard Date: June 1998
Rear housing
Rear terminal PCP
cable (connects to control PCP)P
3. Carefully guide the security PCP wires and connector
through the opening in the vault top.
4. Close, but do not lock, the front housing assembly.
5. Remove the security PCP by removing the screw
holding the security PCP and the PCP support on the
inside of the coin compartment.
Refer to Figure 6-31.
6. To replace the security PCP, reverse the preceding
steps.
Remember to connect the module cable (J31) to the
connector on the rear terminal PCP (J30).
7. Restore the terminal to operation.
Refer to Restoring the terminal to operation on
page 2-10, if necessary.
a) Reconnect the power to the terminal by recon-
necting the terminal block to the rear terminal PCP.
Upper terminal
block (disconnect
power here)
Security PCP
connector
(J30)