Nortel Millennium M1000 Manual page 39

rprbk203 Page 11 Tuesday, February 16, 1999 9:12 AM
See this If, after connecting power to the
terminal, Telephony board not
responding appears on the
display, with the terminal open and
the handset on the hook, allow the
terminal to power up for three
minutes.
• During this time, the terminal will
not respond to install or mainte-
nance instructions.
• If Telephony board not
responding still shows after
three minutes, replace the tele-
phony PCP.
3. Close the terminal.
4. Turn the L- or T-tool counterclockwise in the housing
aperture to secure the housing.
5. Turn the key in the lock counterclockwise to lock the
terminal.
6. If necessary, install a new coin box.
7. Return the terminal to operation with the appropriate
procedure listed below:
• If you took the terminal out of service manually,
return it to service through the craft interface.
• If you replaced the control PCP, the firmware,
the validator, or the escrow, run the INSTALL
routine.
Note: You must lock the terminal to properly end
this procedure.
• If you replaced the telephony PCP, use the mainte-
nance level of the craft interface to perform a
forced download.
Millennium Multi-pay-based terminals: replacing parts
Accessing the terminal 2-11