Nortel Millennium M1000 Manual page 245

rprbk203 Page 7 Tuesday, February 16, 1999 9:12 AM
Figure 7-4: Connecting the display to the control PCP
Keypad
PCP cable
d) Feed the cable under the PCP assembly.
e) Connect the Coin basic portable display cable to
the connector on the control PCP (J7).
Refer to Figure 7-4.
f) Reseat the PCP assembly in the brackets.
g) Reconnect any cables you disconnected.
PCP assembly
Connect
temporary VFD
to this connector (J7)
Clamp plate
5. Restore the terminal to the craft interface level.
Refer to Restoring the terminal to operation on
page 2-10, if necessary.
a) Reconnect the power to the terminal by recon-
necting the terminal block to the rear terminal PCP.
b) Remove your ESD strap connection.
c) Close the terminal but do not lock it.
Millennium Multi-pay-based terminals: replacing parts
Coin basic w/o display 7-7
Handset
cord
Control PCP
Black plastic cover
sits on clamp plate