Nortel Millennium M1000 Manual page 194

rprbk203 Page 12 Tuesday, February 16, 1999 9:12 AM
6-12 Coin path modules
Figure 6-11: Locating the coin rejection chute partition
Outside of
coin rejection
chute
NTP: 506-6501-203 Issue: 00.01 Status: Standard Date: June 1998
c) When you have cleared the jam, replace the
runway covers.
Vandal-deterrent validator:
• If the validator has the three runway pins
ensure they are properly in place in the
sockets on the validator body.
• Fit the upper runway cover over the pins so
that it sits flush to the validator body.
• Replace the steel rods which secure the
covers.
12. Remove the partition from inside the coin rejection
chute validator, if desired. Refer to Figure 6-11.
a) Detach the coin rejection chute by gently
squeezing the sides together to free the tabs and
pulling it away from the terminal.
Partition tab
Partition
(in initial bent
position)
Note: Tabs along
edges of the
coin rejection chute
fit into holes on the
validator body
Inside of
coin rejection
chute