Nortel Millennium M1000 Manual page 152

rprbk203 Page 10 Tuesday, February 16, 1999 9:12 AM
5-10 Card and hookswitch parts
NTP: 506-6501-203 Issue: 00.01 Status: Standard Date: June 1998
10. Replace the PCP assembly as explained in Remov-
ing the PCP assembly on page 3-2, if you removed
it in step 2.
11. When you reconnect the cables to the PCP assembly,
ensure that any excess lengths are folded away from
the terminal housing.
This is especially important for the card reader cable.
Refer to Folding the card reader cable on page 5-11
for specific instructions.
12. Restore the terminal to operation.
Refer to Restoring the terminal to operation on
page 2-10, if necessary.
a) Reconnect the power to the terminal by recon-
necting the terminal block to the rear terminal PCP.
b) Remove your ESD strap connection.
c) Close and lock the terminal.
d) If you upgraded the card reader from a mag-stripe
only to a multi-card reader, do an INSTALL.
e) If you replaced the card reader with the same type
of reader, run the craft interface card reader test.
13. Do functional tests to ensure the card reader and the
terminal are working properly.