Table of Contents
Advertisement
rprbk203 Page 52 Tuesday, February 16, 1999 9:12 AM
6-52 Coin path modules
Figure 6-42: Remove forward screw from hinge
Rear housing
Escrow sits over
this hole
Left hinge
Remove this
hinge screw
Coin return
retainer
screw
Coin return
NTP: 506-6501-203 Issue: 00.01 Status: Standard Date: June 1998
2. Remove the screw at the front of the hinge located on
the left side of the rear housing. Refer to Figure 6-42.
3. Install the coin return bracket.
•
Slide the coin return bracket at a slight forward an-
gle into the hole in front of the hinge bracket.
Refer to Figure 6-43, top inset.
•
As you slide the bracket in, straighten it so it strad-
dles the projection on the coin return housing. Re-
fer to Figure 6-43, bottom picture.
•
When the bracket sits flat on the hinge bracket it is
properly installed.
If it does not sit flat, remove it and try again at a
slightly different angle.
Advertisement
Table of Contents
