Nortel Millennium M1000 Manual page 116

rprbk203 Page 10 Tuesday, February 16, 1999 9:12 AM
4-10 Upper bezel components
NTP: 506-6501-203 Issue: 00.01 Status: Standard Date: June 1998
c) Grasp the cable connector firmly and pull up.
d) Install a new cable:
• Line the cable connector up straight with
the connector on the display PCP.
• Ensure that both ends of the cable connect
so that the number one pin connects in the
same place for both connectors.
WARNING Crossing the connections on this
cable will damage the compo-
nents.
• Press firmly down on the cable connector
until the tabs re-engage.
e) Replace the black plastic cover over the back of
the display assembly. Ensure that all four tabs are
properly hooked under.
3. If the assembly itself is damaged, follow these steps
to remove the display assembly:
a) Use one hand to support the ID bezel on the
outside of the terminal.
b) Remove the two screws which attach the assembly
and the ID bezel to the terminal.
Use a #1 type 1A cross-recess screwdriver.
Refer to Figure 4-9.
c) Remove the ID bezel and set it aside.
d) Remove the two screws attaching the bottom of
the assembly to the terminal.
Refer to Figure 4-5.