Nortel Millennium M1000 Manual page 105

rprbk203 Page 37 Tuesday, February 16, 1999 9:12 AM
Figure 3-22: External interface hookswitch connections
Alerter
To
smart
card
alert
board
(J52)
smart card alert
interconnect cable
connector
Ribbon
cable
connects
to telephony
PCP
External interface
hookswitch module
(ensure the rain
shield in place)
5. Restore the terminal to operation.
Refer to Restoring the terminal to operation on
page 2-10, if necessary.
a) Reconnect the power to the terminal by recon-
necting the terminal block to the rear terminal PCP.
b) Remove your ESD strap connection.
c) Close and lock the terminal.
6. Test the alarm:
a) Take the handset off-hook.
b) Insert a smart card into the card reader.
c) Place the handset back on hook.
d) Wait for the alarm to sound.
e) Remove the smart card.
Millennium Multi-pay-based terminals: replacing parts
PCP assembly components 3-37
Keypad PCP
Mylar
keypad
cable