Nortel Millennium M1000 Manual page 80

rprbk203 Page 12 Tuesday, February 16, 1999 9:12 AM
3-12 PCP assembly components
Figure 3-6: Releasing PCP assembly components
Control/telephony
PCP connector
J4
Telephony PCP
NTP: 506-6501-203 Issue: 00.01 Status: Standard Date: June 1998
(ESD) warning
Failure to follow
these precautions
may damage ESD-
sensitive
components.
• removed the PCP assembly from the terminal. Re-
fer to Removing the PCP assembly on page 3-2.
2. Disconnect the cable connection between the tele-
phony and control PCPs (J4). Refer to Figure 3-6.
3. Release the tabs holding the PCP in the frame. Refer
to Figure 3-6.
• Before working with the
PCP assembly, put on your
ESD wrist strap and connect
it to the ESD connection
points.
• Disconnect the supplemen-
tary power supply.
• Do not reconnect until you
are ready to close the ter-
minal.
• Place any components you
remove from the terminal
into an anti-static bag.
Lift these tabs
to release the
PCPs
Control
PCP