Nortel Millennium M1000 Manual page 135

rprbk203 Page 29 Tuesday, February 16, 1999 9:12 AM
Figure 4-26: Removing the upper bezel assembly
$
10. Remove the quick access keys or blank bezel from the
upper bezel assembly as described in Replacing the
quick access keys bezel on page 4-16.
11. Install the quick access keys bezel on the new upper
bezel assembly.
Remember to loosen the screws three turns so the up-
per bezel assembly fits over the tab on the card read-
er.
12. Replace the upper bezel assembly by reversing the
preceding steps.
Remember to tighten the two screws behind the quick
access keys bezel.
13. Reinstall the PCP assembly as explained in Remov-
ing the PCP assembly on page 3-2.
14. Restore the terminal to operation.
Refer to Restoring the terminal to operation on
page 2-10, if necessary.
a) Reconnect the power to the terminal by recon-
Millennium Multi-pay-based terminals: replacing parts
Upper bezel components 4-29
Grasp assembly
by the sides
and pull from
terminal
Quick access keys bezel
(remove and install on
new bezel)