Nortel Millennium M1000 Manual page 114

rprbk203 Page 8 Tuesday, February 16, 1999 9:12 AM
4-8 Upper bezel components
NTP: 506-6501-203 Issue: 00.01 Status: Standard Date: June 1998
To replace the graphical display, follow these steps:
1. This procedure assumes you have followed the direc-
tions in Preparing the terminal for maintenance on
page 2-3 and Opening and closing the terminal on
page 2-6, including:
Upload CDRs
before you
start
• attached your ESD wrist strap to an ESD connec-
tion point inside the terminal
• confirmed that the power has been disconnected
from the rear terminal PCP
Electrostatic
discharge
(ESD)
Failure to follow
these precautions
may damage ESD-
sensitive
components.
• removed the PCP assembly as explained in
Removing the PCP assembly on page 3-2 and
put it in an anti-static bag and set it aside.
Note display cable connections in Figure 4-8
• Upload the CDRs to the Mil-
lennium Manager before you
start internal maintenance
procedures.
• Before working with the PCP
assembly, put on your ESD
wrist strap and connect it to
the ESD connection points.
• Disconnect the power.
• Do not reconnect until you
are ready to close the ter-
minal.
• Place any components you
remove from the terminal
into an anti-static bag.