Nortel Millennium M1000 Manual page 55

Multi-pay-based terminal replacing part
Table of Contents

Advertisement

rprbk203 Page 27 Tuesday, February 16, 1999 9:12 AM
Figure 2-17: Reconnecting the handset cable
Teladapt
connector
on telephony
PCP
Handset
cord
(no armoring)
Cord enters
through swivel
10. To replace the handset and swivel, reverse the pre-
ceding steps.
Make sure the black sheathing is inserted into the
swivel by at least an inch.
When you reconnect the handset cable to the tele-
phony PCP, ensure that you tuck it under the tele-
phony/control PCP interconnect cable and
reconnect that cable.
11. Restore the terminal to operation.
Refer to Restoring the terminal to operation on
page 2-10, if necessary.
a) Reconnect the power to the terminal by recon-
necting the terminal block to the rear terminal PCP.
b) Remove your ESD strap connection.
c) Close and lock the terminal.
Millennium Multi-pay-based terminals: replacing parts
Accessing the terminal 2-27
Interconnect
cable

Advertisement

Table of Contents
loading

Table of Contents