Nortel Millennium M1000 Manual page 115

Multi-pay-based terminal replacing part
Table of Contents

Advertisement

rprbk203 Page 9 Tuesday, February 16, 1999 9:12 AM
Figure 4-8: ADSI board display connection
Graphical
display
assembly
Front
housing
PCP assembly
Multi-application
control PCP
ADSI
(removes as part of control PCP)
WARNING
2. The display assembly cable can be replaced separate-
ly from the module if only the cable is damaged.
Follow these steps to replace a damaged cable:
a) Remove the black, plastic cover from the back of
the display assembly.
There are four tabs holding it on, two at the top, and
one on either side.
b) Press down on the tabs on either side of the
connector attached to the ribbon cable to release
the cable connector.
Millennium Multi-pay-based terminals: replacing parts
Upper bezel components 4-9
Rear
terminal
connector (J5)
(disconnect first!)
Graphical display
connector (on ADSI board)
daughter board
Connectors:
To disconnect cable connectors
from PCP connectors, press down
on the tabs on the sides of the
connectors.

Advertisement

Table of Contents
loading

Table of Contents