Nortel Millennium M1000 Manual page 101

rprbk203 Page 33 Tuesday, February 16, 1999 9:12 AM
Figure 3-17: External interface hookswitch SCA connections
Alerter
To
smart
card
alert
board
(J52)
smart card alert
interconnect cable
connector
Ribbon
cable
connects
to telephony
PCP
External interface
hookswitch module
(ensure the rain
shield in place)
Figure 3-18: Smart card alert board connections
4-pin connector for smart card alert
J36
interconnect cable
3-pin connector for alerter link
J37
24-pin connector (below board)
inserts into U25 socket
8. Ensure that all the connectors are properly seated.
9. Restore the terminal to operation.
Refer to Restoring the terminal to operation on
page 2-10, if necessary.
a) Reconnect the power to the terminal by recon-
necting the terminal block to the rear terminal PCP.
b) Remove your ESD strap connection.
Millennium Multi-pay-based terminals: replacing parts
PCP assembly components 3-33
Keypad PCP
Mylar
keypad
cable