Nortel Millennium M1000 Manual page 149

rprbk203 Page 7 Tuesday, February 16, 1999 9:12 AM
Figure 5-7: Positioning a bent card guide
Card slot
(card reader
bezel
attaches
at this end)
Credit card
inserted into
card reader
slot
b) If a new multi-card reader does not have a card
guide as part of the card reader housing, check the
old reader for this piece and snap it on to the new
card reader. Refer to Figure 5-7.
Multi-card reader, lower view
Card guide
supports card
entry
7. Reassemble the card reader assembly by reversing
the process in step 6.
• Ensure that the card reader slot on the card reader
is centered with the card reader slot of the bezel.
Refer to Figure 5-8.
• Ensure that the gasket around the card reader be-
zel is sitting properly in its channel.
Multi-card reader:
a) Ensure that the micro-switch actuator of the rail is
operational.
To test: Insert a smart card part way into the
reader. When the card first enters the slot and
when it is removed, you should hear a click.
Figure 5-8 shows the switch actuator.
b) Remember to re-tighten the two screws on the
keypad PCP that hold the interlock tab in place.
Refer to Figure 5-4.
Millennium Multi-pay-based terminals: replacing parts
Card and hookswitch parts 5-7
Edge hooks over
screws on
card reader
PCP
Bottom edge
of card guide
fits over
bottom edge
of card reader