Nortel Millennium M1000 Manual page 225

rprbk203 Page 43 Tuesday, February 16, 1999 9:12 AM
Installing the switch and bracket
The following procedure describes how to install an e-lock,
and an e-lock security switch and bracket.
1. This procedure assumes you have:
• arranged for a coin box pickup
Note: Do not put a new coin box into the coin vault,
unless otherwise instructed
• put the terminal out of service
• followed the steps in Preparing the terminal for
maintenance on page 2-3 and Opening and clos-
ing the terminal on page 2-6
• attached your ESD strap to an ESD point inside the
terminal
• confirmed the power is disconnected at the rear
terminal PCP
Electrostatic • Before working with the internal
discharge
(ESD)
• Place any components you re-
Warning • Disconnect the power before
• Do not reconnect the power
Failure to follow these
precautions may damage
the ESD-sensitive components
of the PCPs.
Millennium Multi-pay-based terminals: replacing parts
Coin path modules 6-43
boards, put on your ESD wrist
strap and connect it to an ESD
connection point inside the ter-
minal.
move from the terminal into an
anti-static bag or onto an anti-
static surface.
you disconnect any other ca-
bles.
until you are ready to close
the terminal.