Nortel Millennium M1000 Manual page 121

rprbk203 Page 15 Tuesday, February 16, 1999 9:12 AM
Figure 4-13: Installing the abrasion shield
5. To install the new abrasion shield:
a) Ensure the track around the window is clear of any
debris.
b) Clean the display area, if necessary. Remove all
dust and fingerprints to optimize readability.
c) Hold the new abrasion shield by the edges and
remove the protective plastic.
d) Place the lower edge under the bottom lip of the
window opening.
e) Apply pressure to the outer edges of the shield,
bending it until it snaps under all four edges.
Figure 4-31 shows the positioning in the window.
Millennium Multi-pay-based terminals: replacing parts
Upper bezel components 4-15
Abrasion
shield
Display window