Nortel Millennium M1000 Manual page 118

rprbk203 Page 12 Tuesday, February 16, 1999 9:12 AM
4-12 Upper bezel components
Figure 4-10: Removing the graphical display assembly
Assembly
fits under
lock
NTP: 506-6501-203 Issue: 00.01 Status: Standard Date: June 1998
4. Install the display assembly into the terminal.
a) Hold the display assembly at the top and bottom at
about a 45-degree angle and fit it under the lock
and swivel casings.
b) Shift the assembly until it sits flat in the window
area of the front housing.
c) Reattach the bottom two screws to hold the
assembly in place.
d) Replace the ID bezel on the front of the terminal.
Replace the top screws which hold the display
assembly and the ID bezel to the housing.
5. Reinstall the PCP assembly as explained in Remov-
ing the PCP assembly on page 3-2.
Keypad
PCP
Display
assembly
Front housing