Nortel Millennium M1000 Manual page 241

rprbk203 Page 3 Tuesday, February 16, 1999 9:12 AM
Flowchart
Figure 7-2: Flowchart — installing/removing internal display, page 1
At the terminal site
Follow all the steps for
preparing the terminal for
maintenance, including:
Access the terminal and
unlock and open the housing.
Connect ESD strap inside
the terminal.
Disconnect power:
Disconnect terminal
block from the rear
terminal PCP
Remove black plastic
window cover (set aside)
Set the portable display unit
on the screw posts of the
clamp plate
Connect the display cable
to the control PCP
Reconnect power at
the rear terminal PCP
Disconnect ESD strap
The following flow chart describes the process of installing
and removing the Coin basic portable display.
Close housing and lock
with T-tool
Upload CDRS
(You may need to re-enter
the craft interface)
Run craft interface
maintenance tests
Uninstall the terminal
Millennium Multi-pay-based terminals: replacing parts
Coin basic w/o display 7-3
Do
you need to No
run craft
interface
tests?
Yes
Are
you replacing
No
control PCP
or firmware?
Yes
Continued on next page