Table of Contents
Advertisement
rprbk203 Page 23 Tuesday, February 16, 1999 9:12 AM
Figure 6-19: Locating coin guide screws
Screws that secure
ID bezel
to front housing
4. Remove the two screws securing the ID bezel. Refer
to Figure 6-18.
5. Remove the ID bezel from the terminal.
6. Remove the coin guide from the ID bezel by unscrew-
ing the two M3.5 screws securing the guide to the be-
zel. Refer to Figure 6-19.
7. To replace the coin guide, reverse the preceding
steps.
8. Ensure that both the coin guide gasket and the ID be-
zel gasket are in good condition.
Replace any damaged gasket.
9. Reinstall the PCP assembly. Refer Removing the
PCP assembly on page 3-2, if necessary.
Coin guide screws
10. Restore the terminal to operation.
Refer to Restoring the terminal to operation on
page 2-10, if necessary.
a) Reconnect the power to the terminal by recon-
necting the terminal block to the rear terminal PCP.
b) Remove your ESD strap connection.
c) Close and lock the terminal.
11. Perform coin tests to ensure the coin slot is properly
lined up with the validator runway.
Millennium Multi-pay-based terminals: replacing parts
Coin path modules 6-23
ID
bezel
(inside)
ID bezel
gasket
fits in this
groove
Advertisement
Table of Contents
