Nortel Millennium M1000 Manual page 165

rprbk203 Page 23 Tuesday, February 16, 1999 9:12 AM
Figure 5-20: Bezel B alerter connection to hookswitch
Alerter PCP
Alerter or
smart card
alert connector
Ribbon
cable
connects
to telephony
PCP
Hookswitch
PCP
Mylar
keypad
cable
Keypad PCP
• If the terminal has the smart card alert feature and
a multi-application control PCP, disconnect J14
from the J2 connector located on the right edge of
the multi-application control PCP.
3. To remove the alerter bezel, remove the two M3.5 tap-
ping screws securing the alerter module to the bezel.
• Refer to Figure 5-21.
• Use a #2 type 1A cross-recess screwdriver.
• Ensure that the acoustic membrane held between
the alerter and housing assemblies remains in
place when replacing the alerter module.
Millennium Multi-pay-based terminals: replacing parts
Card and hookswitch parts 5-23