Nortel Millennium M1000 Manual page 158

rprbk203 Page 16 Tuesday, February 16, 1999 9:12 AM
5-16 Card and hookswitch parts
Figure 5-15: Installing the teladapt support inside the bezel
Teladapt support piece
L-shaped slot
Sloping front
Inside of card reader
bezel
Boot gasket
Boot gasket
NTP: 506-6501-203 Issue: 00.01 Status: Standard Date: June 1998
3. Remove the PCP assembly.
Refer to Removing the PCP assembly on page 3-2.
4. Remove the card reader assembly.
Refer to Working with the card reader assembly on
page 5-2.
5. Unscrew the card reader from the bezel.
6. Attach the black rubber datajack support piece to the
card reader so it sits behind the teladapt plug. Refer
to Figure 5-15.
7. Attach the new bezel to the card reader.
Ensure that you do not pinch the datajack cable.
8. Reinstall the card reader into the terminal.
Ensure that the gasket around the card reader bezel
is in place and in good condition.
Note: You may have to remove it from the old bezel
and install it on the new one. Refer to Figure 5-15.
Microswitch
The L-shaped slot fits here,
with the sloping face to the
front