Nortel Millennium M1000 Manual page 189

rprbk203 Page 7 Tuesday, February 16, 1999 9:12 AM
Figure 6-5: Validator cable connections
Coin validator
Validator/
escrow
connection
Escrow PCP
Telephony PCP
(Control PCP is on
the other side of the
PCP assembly)
Electrostatic • Before working with the in-
discharge
(ESD)
• Place any components you
Warning
• BEFORE YOU DISCON-
• Do not reconnect power un-
Failure to follow these precautions may damage the
ESD-sensitive components.
Refer to Figure 6-5 for validator cable locations.
Millennium Multi-pay-based terminals: replacing parts
Coin path modules 6-7
ternal boards, put on your
ESD wrist strap and con-
nect it to an ESD connection
point inside the terminal.
remove from the terminal
into an anti-static bag or
onto an anti-static surface.
NECT ANY CABLES, dis-
connect the power.
til you are ready to close the
terminal.
Rear housing
Validator connection
to control PCP
(thread under the
PCP assembly)
J33/J8
Front
housing