Nortel Millennium M1000 Manual page 91

Multi-pay-based terminal replacing part
Table of Contents

Advertisement

rprbk203 Page 23 Tuesday, February 16, 1999 9:12 AM
Uninstall the
Since you are replacing the
control PCP, uninstall the
terminal
terminal before disconnecting
the power.
attached your ESD wrist strap to the ESD connec-
tion point inside the terminal
disconnected the power from the rear terminal PCP
ESD and
• Connect your ESD wrist strap
power
warning
• Disconnect the power: discon-
• Do not reconnect the power
removed the PCP assembly from the terminal
removed the control PCP from the PCP assembly
and place the PCP assembly in an anti-static bag
2. Grasp the daughter board firmly and pull straight up,
off the control PCP.
3. Put the old control PCP in an anti-static bag for dispos-
al or repair.
4. On the new control PCP, line up the daughter board
connectors over the male connector pins on the con-
trol PCP.
Note: Position the SAM daughter board so that the
sockets face to your left.
The connectors should match up so that the blocked
part of the connector of the daughter board matches
with the missing pin on the control PCP.
Millennium Multi-pay-based terminals: replacing parts
PCP assembly components 3-23
to the ESD connection points
inside the terminal.
nect the terminal block from
the rear terminal PCP.
until you are ready to close the
terminal.

Advertisement

Table of Contents
loading

Table of Contents