Table of Contents
Advertisement
rprbk203 Page 40 Tuesday, February 16, 1999 9:12 AM
6-40 Coin path modules
Figure 6-33: Replacing the coin vault lock
$
NTP: 506-6501-203 Issue: 00.01 Status: Standard Date: June 1998
2. Remove the key from the coin compartment lock.
3. Remove the four screws securing the coin compart-
ment lock. Refer to Figure 6-33.
4. Reverse steps 1 to 3 to replace the coin compart-
ment lock.
5. Replace the security PCP as explained in Replacing
the security PCP on page 6-34.
6. Reconnect the terminal block to the rear terminal PCP
to reconnect the power.
7. Test the switches to ensure that the lock is positioned
so its micro-switch actuator is activated by locking the
coin compartment and deactivated by unlocking it.
8. Restore the terminal to operation.
Refer to Restoring the terminal to operation on
page 2-10, if necessary.
a) Remove your ESD strap connection.
b) Close and lock the terminal.
9. Insert a new coin box into the coin vault.
Coin vault
Security PCP
Coin compartment
lock
Two screws that
secure the coin lock
(the upper two are not
visible in this
illustration)
Advertisement
Table of Contents
