Table of Contents
Advertisement
rprbk203 Page 11 Tuesday, February 16, 1999 9:12 AM
8. Remove the Coin basic portable display.
Note: If the instruction card is an internal card, do the
following:
a) remove the ID bezel
b) lift the clamp plate
c) replace the card
d) replace the clamp plate and ID bezel.
9. Set the black plastic window cover over the screw
posts of the clamp plate, covering the display cutout in
the clamp plate.
10. Reseat the PCP assembly securely in its brackets.
11. Reconnect whichever cables you disconnected to lift
the assembly.
12. Check that all the cables are fully seated in their con-
nectors and excess cable is folded and tucked out of
the way of the edges of the terminal.
13. Restore the terminal to operation.
Refer to Restoring the terminal to operation on
page 2-10, if necessary.
a) Reconnect the power to the terminal by recon-
necting the terminal block to the rear terminal PCP.
b) Remove your ESD strap connection.
c) Close and lock the terminal.
14. If required, replace the external instruction card.
15. Perform operations tests to ensure the terminal is
working.
Millennium Multi-pay-based terminals: replacing parts
Coin basic w/o display 7-11
Advertisement
Table of Contents
