Table of Contents
Advertisement
rprbk203 Page 50 Tuesday, February 16, 1999 9:12 AM
6-50 Coin path modules
NTP: 506-6501-203 Issue: 00.01 Status: Standard Date: June 1998
3. If the terminal has a coin return bracket, remove it and
set aside.
Refer to Coin return bracket upgrade on page 6-51,
if necessary.
Note: Older terminals may not have this part.
4. Close the front housing cover to allow access to the
front of the coin return assembly.
5. Grasp the coin return assembly by placing your index
finger into the coin return door and your thumb on the
upper surface of the coin return door.
Refer to Figure 6-40.
6. Lift the coin return assembly up about 3 mm, and then
pull it away from the terminal as much as possible.
7. Lift and rotate the coin return assembly above the up-
per end of the coin return bezel and remove.
8. To replace the coin return assembly, reverse the pre-
ceding steps.
9. When you are ready to close the housing, remove
your ESD strap connection and close and lock the
housing assembly.
Refer to Restoring the terminal to operation on
page 2-10, if necessary.
Advertisement
Table of Contents
